CyberPower PDU15SW8RNET Manuale Utente Scaricare il pdf (Pagina 32)

PowerPanel™ Business Edition

Users can manage connected loads and outlets from the Load Management page. All connected equipment

and computers can be listed with detailed information including the name, location, contact, and what type of

outlet the equipment is plugged into.

Agent computer is the default computer which is added into the list and can’t be removed from the list. Users

can only modify the name, location, contact and assign the outlet.

z Add a new Client computer: Click the target outlet you want to add a new piece of equipment to the list

and then click Yes on the Enabled option. If the equipment has PowerPanel

Business Edition Client

installed, click Yes on the PowerPanel installed option and enter the Client computer's IP address.

Click the Apply button to finish adding the new equipment. After communication with the Client computer

is established, the information such as the name, location, contact, and connected outlet will be obtained

from the remote Client computer.

Note: The Client computer is a remote computer which has PowerPanel

Business Edition Client

installed. A computer without PowerPanel

Business Edition Client installed cannot establish

communication with PowerPanel

Business Edition Agent.

z Add new generic equipment: Click the target outlet you want to add a new piece of equipment to the

list and then click Yes on the Enabled option. Click No on the PowerPanel installed option and enter the

name and optional information for the equipment connected to the outlet. Click the Apply button to finish

adding the new equipment.

Note: The generic equipment mentioned is connected equipment of any type that does not run

PowerPanel

Business Edition Client.

z Modify the equipment: Click the equipment you wish to modify from the equipment list. After entering in

the new data, click the Apply button to complete.

z Remove the equipment: Click the equipment you wish to remove from the equipment list. Click No on

the Enabled option and then click Apply to complete the removal.

Assigning a correct outlet is important. The Connected Outlet option must be configured to match the actual

equipment plugged into the UPS outlet. Depending on the UPS configuration of specific models with NCL

outlets, these outlets will lose power before the entire UPS is shutdown. The Agent will request Client

computers powered by these outlets to perform a shutdown to avoid data loss because of the power outage.

Note: The Client computer name will be displayed in gray if communication with the Client computer is not

established.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 99 100

Nessun commento

CyberPower PDU15SW8RNET Manuale Utente Pagina 32